You need to tape it to your project before you send it through your machine. It needs to be fairly taut so that it doesn’t move too much as the tool heats the areas of the design.
Remember to remove the heat protector if you need to scan again. Important: before you remove your mat after the design has been completed, remove the foil and double-check that all of your design has been foiled.If any has been missed then re-place the foil on your project and send it through the cycle again. This system is compatible with the following die cutting system: Once you remove your mat the above will not work as the mat will not load in exactly the same place to achieve a nice outcome. Deep Sea Die Cutting and Embossing Machine.Plug in your machine and place the Glimmer Hot Foil Platform into the charging base.Turn on the system and wait for it to fully heat up the three handy system lights will help you know when it's ready.Īlso get your die cutting machine ready by removing any adapters or cutting pads.Take your Spellbinders Glimmer Hot Foil Plate and place it on the rubber portion of the platform face up.This measures the appropriate amount of time to fully heat your plate.
When it's ready, the timer button turns solid green. Place your foil shiny side down on top of the Glimmer Plate.Then add your desired material on top of it. If using cardstock, make sure you use a smooth texture for the best coverage. Add the included shim and spacer plate next.Īlso, be careful: the platform and the plate will be very hot.
0 kommentar(er)
